Buffalo LinkStation Mini User Manual download pdf (Page 137)

Chapter 4 Web Admin interface

LinkStation User Manual 136

Name

Descriptions

Storage

RAID Array *1

*1: LS-WXL,

LS-WSXL only

Congure RAID array from this menu.

RAID 0 and RAID 1 mode are available for use. LinkStation will be used just as

the two hard drives if RAID setting is disabled.

Disk Structure:

Displays the hard drive conguring RAID. To congure a RAID array, check the

target drive, select RAID mode and click [Create Raid Array]. To delete the RAID

array, select [Delete RAID Array].

Changing RAID Array setting causes data loss. Back up any important data in

advance.

[RAID Array Error Detection Response]:

When there is an error on RAID Array, the system will be automatically shut

down to protect data (This feature is only for RAID 1. This does not work

under normal mode or RAID 0 mode).

The default setting is [Shutdown].

[RAID Array check speed]:

Select the speed of the RAID Scan from the following

[High]: 10 hours per 1 TB RAID Array

[Normal]: 20 hours per 1 TB RAID Array

[Low]: 100 hours per 1 TB RAID Array

RAID Scanning *1

*1: LS-WXL,

LS-WSXL only

A RAID scan tests your RAID array for errors. If errors are found, they are xed

automatically if possible. If you are using a RAID array, regular RAID scans are

recommended.

Recoverable errors found during standard le operations will be automatically

repaired regardless of performing RAID Scanning or not.

Status Descriptions

Recoverable errors • Read error in the data area which are build in

RAID 1(including RAID 1 system area)

Unrecoverable errors • Writing error / RAID management area error /

drive partition information area / Drive Detection

Failure

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 170 171

No comments

Buffalo LinkStation Mini User Manual Page 137