Buffalo LinkStation Mini User Manual download pdf (Page 169)

LinkStation User Manual 168

Appendix

Troubleshooting

Cannot Setup

The following section lists typical occurrences and causes when you cannot setup the LinkStation

by using LinkNavigator or cannot use LinkStation even after nishing setup,

Occurrence: The message "Cannot find LinkStation", "No available LinkStation was found", or

"Setup cannot be completed" is displayed.

Cause 1. An Ethernet cable is not connected.

Reconnect the AC Adapter and the Ethernet cable, and turn on the LinkStation again.

Cause 2. The rewall is enabled, or software running in the background is installed.

Disable the rewall or uninstall software which enables the rewall, and try to search for the

LinkStation again.

Cause 3. Both wireless and Ethernet Adapter are enabled.

Disable any adapters other than the Ethernet Adapter to connect to the LinkStation.

Cause 4. The defective Ethernet cable or the connection is not stable.

Change a port on the hub to connect or replace the Ethernet cable.

Cause 5. Your Ethernet Board, card, or adapter is malfunctioning.

Replace a Ethernet Board, card, or adapter.

Cause 6. The Ethernet Board you are using or the transfer mode of the hub is not set.

Change the Ethernet Board, or change the transfer mode to [10M half-duplex] or [100M

half-duplex].

Some Ethernet Boards and hubs may not be connected to the network properly if the trans-

fer mode is set to [Auto Negotiation].

Cause 7. There is a network bridge.

If any network bridge which is not used, delete them.

Cause 8. You are searching from a dierent network.

You cannot search for the LinkStation over network segments. Connect the LinkStation to

the same segment as the computer you use for search.

1 2 ... 164 165 166 167 168 169 170 171

No comments

Buffalo LinkStation Mini User Manual Page 169